John Sweeney

Ian M. Ward

Providing an updated and comprehensive account of the properties of solid polymers, the book covers all aspects of mechanical behaviour. This includes finite elastic behavior, linear viscoelasticity and mechanical relaxations, mechanical anisotropy, non-linear viscoelasicity, yield behavior and fracture. New to this edition is coverage of polymer nanocomposites, and molecular interpretations of yield, e.g. Bowden, Young, and Argon. The book begins by focusing on the structure of polymers, including their chemical composition and physical structure. It goes on to discuss the mechanical properties and behaviour of polymers, the statistical molecular theories of the rubber-like state and describes aspects of linear viscoelastic behaviour, its measurement, and experimental studies. Later chapters cover composites and experimental behaviour, relaxation transitions, stress and yielding. The book concludes with a discussion of breaking phenomena.

Mechanical Properties of Solid Polymers

The last four years since the publication of the first of this series have seen further striking developments in both the science and technology of oriented polymers. In particular, polymers possessing very high degrees of molecular orientation are now quite commonplace, and this is reflected by the inclusion of five chapters dealing with ultra-high modulus polyethylene fibres, oriented liquid crystalline polymers (both lyotropics and thermo tropics) and polydiacetylene single crystal fibres. At the same time there is continuing interest in the structure and properties of less highly oriented polymers and in the mechanisms of deformation in polymers. It is therefore good to have these themes represented also. I should like to thank the contributors for adhering to a rather tight time schedule, and the publishers for their cooperation, so that this book can provide up-to-date reviews of the state of the art in a rapidly moving area of polymer science. I. M. WARD v CONTENTS Preface.... . . . .. . . . . .. ... . . . . . . . . . .. . . .. . . . . . . ... ... v List of Contributors. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . IX 1. Polymer Single Crystal Fibres ........................ .

Developments in Oriented Polymers—2

The first edition was produced at a time when the advantages of studying oriented polymers were just becoming apparent. From a sci entific stand point it had been demonstrated that greater insight into both structure and properties could be obtained if an oriented polymer was prepared. From a technological viewpoint, major advances were under way, especially in high modulus and high strength fibres. Twenty years later, it is possible to review the scientific advances which have been made in this area and to provide much wider perspectives for the technology. As in the case of the first edition, the emphasis is on the methodologies available for characterizing oriented polymers and their mechanical behaviour. It is a particular pleasure to thank the contributing authors for their cooperation and Dr Philip Hastings of Chapman & Hall for his support and encouragement. I am also indebted to Professors A. H. Windle and D. C. Bassett for their respective contributions to sections 1. 3. 1 and 1. 3. 4. Although this chapter has been extensively revised, the contribution of the late Leslie Holliday to the first edition of this book is also acknowledged. Introduction 1 I. M. Ward 1. 1 THE PHENOMENON OF ORIENTATION Orientation in polymers is a phenomenon of great technical and theo retical importance. The word orientation itself conveys a number of ideas.

Ian M. Ward

About

Books

Join the club